Whittington Cricket Club – Sanding and sealing of existing flooring in main hall using Bona Traffic HD lacquer. Uplift of damaged flooring in corridor and installation of Kahrs 3 strip engineered plank flooring.
A new Boen 13 x 181 x 2200mm engineered floor was installed in a House of Fraser concession area within London
The existing flooring suffered water damage and needed to be replaced, this was removed and the new Boen floor was to be installed. A new plywood subfloor was installed to raise the height before the new flooring was installed. The original floor trims were used along with new Gradus trims
Continue Reading →
Existing oak floor restoration at the City of Birmingham Orchestra. The oak floor needed to be restored including a couple of repairs due to damage to existing oak flooring, the work was to include 2 studios. These needed to be completed first to allow for use later in the week, with the main hall to be completed last.
The main hall had some repairs to be undertaken to the oak floor before finally it could be sanded back to bare and ...Continue Reading →
Junckers Sports Flooring
A new Junckers Sylvasport Premium solid beech floor over Blubat battens was required to be installed as per the schools specification.
We supplied and installed firstly a Sylvathene moisture barrier followed by the Blubat battens. The Sylvasport Premium flooring in beech was installed over the battens using secret mailing. The expansion gap was installed around the perimeter of the flooring as per Junckers recommendations.Continue Reading →
Church Hall Parquet Flooring
We were contacted by St Paul’s Church, Great Barr to take up an existing water damaged wood floor and install a new replacement solid oak parquet block floor.
The original Iroko parquet block floor was removed and the existing floor had a self levelling latex and an epoxy dpm installed.
We then installed new prime grade oak parquet block flooring to the whole floor area and sanded and resealed the floor using a base coat of Bona Prime Classic followed by ...Continue Reading →
We were instructed by Andy at Madeley Town Council to undertake the renovation of the existing maple wood flooring in the Anstice Club in the centre of Madley.
We had to fully sand the existing floor finish off and then repair and also replace up to twenty 57mm maple boards . Once the repairs had been fully completed and the floor sanded to a fine finish, we then applied one base coat of Junckers primer followed by top coats of Junckers HP Commercial floor ...Continue Reading →
A Boen 14mm Oak Animoso with a White Live Natural Oil finish was chosen to be installed at the new museum in Wordsley, Stourbridge.
The existing sub-floor had an epoxy DPM applied (Bona R410), which was allowed to fully dry prior to the Boen engineered strip flooring being installed. The floor requires a finishing coat of White Live Natural Oil applied as a finishing coat prior to the museum opening, which will be in the very near future
Continue Reading →
Restoration and repair to a water damaged mosaic finger panel floor in Ambergate, Derbyshire. the existing finger panel floor had suffered from water damage and the individual finger blocks had come loose under the carpet tiles installed over them in the office.
The carpet tiles were taken up and the individual mosaic finger blocks taken up in the affected areas and put to one side. The sub-floor was then cleaned of all debris and then each mosaic finger block was reinstalled ...Continue Reading →
A new parquet floor was required by Chivenor School in Castle Vale, Birmingham.
The existing floor was taken up, the existing screed sub-floor had a Bona R410 DPM applied and allowed to fully dry. We then installed an oak 230 x 70mm parquet floor with a 2 block border to the hall.
This was then sanded to a fine finish using 40-120 grit continuous sanding belts. Once the floor had been fully sanded we applied 1 coat of Bona Prime and 3 ...Continue Reading →
A solid wood floor was required to be installed at Birmingham University. The flooring that was chosen was a 90mm solid oak pre-finished board and this was installed over the existing wood floor.
Additional work was required to inlay the floor boxes and make a border for around the inset fireplace and hearth. Additionally a scotia bead was installed around the perimeter of the floor over the expansion gap and we custom made door ramps to allow for the difference in ...Continue Reading →