Archive for 2016

Parquet Block Flooring – Shrewsbury

230mm x 70mm x22mm Solid Oak Parquet Block Flooring

CMT Flooring were asked to install new solid oak parquet flooring.  The solid oak parquet flooring was fully bonded to the existing screed subfloor using a silane flexible adhesive.  The wood flooring was then sanded and then sealed with Bona Mega floor lacquer.

Continue Reading →
0

Floor Sanding & Sealing, Lichfield Staffordshire

Wood Floor Sanding

The existing floor boards were sanded back to bare wood to remove the old surface finish, they then where sanded to a fine finish before a coat of Bona Prime Classic and 2 coats of Bona Mega floor lacquer were applied giving a beautiful clean look to the floors

Continue Reading →
0

Junckers Floor Installation – Edgbaston, Birmingham

Junckers Sports Flooring

A new Junckers Sylvasport Premium solid beech floor over Blubat battens was required to be installed as per the schools specification.

We supplied and installed firstly a Sylvathene moisture barrier followed by the Blubat battens. The Sylvasport Premium flooring in beech was installed over the battens using secret mailing. The expansion gap was installed around the perimeter of the flooring as per Junckers recommendations.

Continue Reading →
0

Repair to strip flooring, Hopwas Staffordshire

We were asked to restore an original redwood strip floor that has been uncovered when the existing carpet was removed.

The existing fire hearth was still visible, se we had to firstly remove that and apply a self levelling latex to ensure a level area.  Existing redwood strip flooring was then removed from areas around the perimeter of the room and refitted into the previous fire hearth.

New strip flooring was then refitted to the perimeter of the room and stained to ...

Continue Reading →
0

St Paul’s Church, Great Barr Birmingham

Church Hall Parquet Flooring

We were contacted by St Paul’s Church, Great Barr to take up an existing water damaged wood floor and install a new replacement solid oak parquet block floor.

The original Iroko parquet block floor was removed and the existing floor had a self levelling latex and an epoxy dpm installed.

We then installed new prime grade oak parquet block flooring to the whole floor area and sanded and resealed the floor using a base coat of Bona Prime Classic followed by ...

Continue Reading →
0

New Whittington School, Chesterfield

Paul at New Whittington Community Primary School contacted us for the repair and restoration to their existing parquet block floor.

An area of the parquet floor had risen up from the sub-floor and was obviously a health and safety issue for the school and the existing floor finish was tired and worn in places and had a build up of polish around the edges which needed to be removed.

The area of parquet flooring that had come loose was carefully lifted out and ...

Continue Reading →
0

Wolverhampton Girls High School, Wolverhampton

Mark at Wolverhampton Girls High School contacted us to restore existing flooring in two areas by the main reception area.

We arrived at the school and we uplifted the loose parquet blocks in the two areas, cleaned out any debris from the previous adhesive used to stick the blocks down.

The blocks were then refitted into place using Bona R484 silane adhesive and allowed to dry prior to the next step.

The floor was then sanded to a fine finish and had one ...

Continue Reading →
0

Anstice Club Madley, Telford, Shropshire

We were instructed by Andy at Madeley Town Council to undertake the renovation of the existing maple wood flooring in the Anstice Club in the centre of Madley.

We had to fully sand the existing floor finish off and then repair and also replace up to twenty 57mm maple boards .  Once the repairs had been fully completed and the floor sanded to a fine finish, we then applied one base coat of Junckers primer followed by top coats of Junckers HP Commercial floor ...

Continue Reading →
0

Parquet Block Floor Edgbaston, Birmingham

We were asked to supply and install a prime grade solid oak parquet herringbone floor to a hallway in Edgbaston, Birmingham.
The existing flooring was removed and we needed to install a layer of self levelling latex and an epoxy dpm before the blocks could be installed.
The prime grade solid oak parquet blocks had been acclimatising for 14 days prior to the installation close to where they were to be installed.

Once the oak parquet had been installed, the 1 ...

Continue Reading →
0

Engineered parquet floor – Leamington Spa

We installed a customer supplied engineered oak parquet floor (the parquet blocks have a tumbled look) to an extension to their property in Leamington Spa.  Most of the floor was installed over a dpm covered screed floor, although some was installed over a plywood floor installed by the client

A two block border was installed to the perimeter of the rooms and it has a natural oil finish

 

 

 

 

 

 

Continue Reading →
0
Page 1 of 2 12